Manual: RB-1.5 / RB-3.0 / RB-3.8
Manual: RB-1.5 / RB-3.0/ RB-3.8
page 4 / 9
page 5 / 9
1. Scope of delivery & details
Please check if all listed parts are included and undamaged. Included in delivery:
1 x laser module
1 x manual
3. Initial operations, safety instructions
1. Make sure to use
correct voltage
; see in-
formation on device & in this manual.
2. Make sure that the device is
not connec-
ted to mains
during installation.
3. Installation has to be done by
technical
experienced and qualified persons
ac-
cording to safety regulations of the res-
pective country.
4. If the device has been exposed to
great
temperature changes
, do not switch
it on immediately. Condensation water
may damage device.
5. Never use dimmer, RC or other electroni-
cally switched sockets. Whenever possib-
le, do not use the module together with
large appliances (especially fog machi-
nes) on the same mains!
6. Ensure that device does
not get over-
heated.
The module must be mounted
to a solid ground plate. Additional hea-
tsinks are necessary in most cases. It is
the responsibility of the customer to use
heatsinks and/or ventilation in proper di-
mension.
4. Working on the device
1. Take off all reflecting things like rings, watches etc. before star-
ting to work with or at the module.
2. Only use non-reflecting tools to work on device.
3. Wear protective clothing (like goggles, gloves etc.) ac-
cording to laser power and wavelength of the laser.
2. Preliminary warning notices
1. Please use this device only
according to these operating instructions
.
2. Do not use the device if there are any
visible damages
on module, connectors or boards.
3.
Never look directly into the light source
of a laser source. Danger of blindness!
4.
Do not operate the device at high humidity, in the rain or in dusty environments.
5.
Protect device against dripping or splashing water.
Warranty claim expires with removal or break of warranty label.
5. Service notes
•
Moisture and heat can reduce lifetime
of the laser module dramatically and ex-
pires any warranty claim.
•
Quick on/off switching of device can re-
duce durability of the laser diode drama-
tically.
•
Avoid concussions during transport.
•
To increase durability of your laser,
protect device against overheating:
- Always ensure sufficient ventilation.
- Check temperature after approx. 30
minutes with each new installation.
If necessary install the projector at a
place with different temperature.
- Keep the device dry. Protect it from
moisture, rain and damp.
-
Switch off device when it is not nee-
ded. Diodes are switched on and can
wear off even if there is no visible la-
ser output.
•
As for troubleshooting, please check the
FAQ on our website www.laserworld.com
•
Removal of the warranty label as well
as damages to the device caused by
improper handling, neglect of the sa-
fety instructions and service notes will
void the warranty.
6. Important notice:
The module must be used with appropriate heatsinks. The heat transmission works through
the ground plate, so the cooling must be handed directly there. The module is not suitable for
fan-cooling only.
