Manual: Laserworld EL-200S DMX
Date: 08/2009
Page 4 of 6
Sound-/automatic mode
In automatic mode the patterns will be displayed automatically in a round robin fashion.
Operating switch 1 will set the device to sound mode. In sound mode the patterns are
changed and animated to the beat of the music. You can control the music-sensitivity of the
microphone with the knob at the front panel, the mic LED flashes when the audio is
triggered.
DMX control
Setting Switch 10 to „off“ puts the device into DMX mode. Connect a DMX controller to
operate the laser. The red LED on the back panel will flash as long as a DMX signal is
detected.
To set the DMX address of the laser use switches 1 to 9, each switch represents a number:
Switch
number
switch
number
1
1
6
32
2
2
7
64
3
4
8
128
4
8
9
256
5
16
10
mode
The address is the sum of all activated numbers, see the following example settings (the
white rectangle represents the position of the switch)
:
Addr switch
addr
switch
1
65
17
113
The laser uses 5 DMX channels, so make sure that the next device uses an address that
doesn’t overlap with this range. E.g. when using address 1, make sure the next device uses
at least address 6.
Channel
value
function
0 – 63
Laser off
64 – 127
Sound mode
128 – 191
Automatic mode
1
192 – 255
DMX mode
2
0 - 255
Pattern
3
0 - 255
Speed
0 – 39
Red
40 - 79
Green
80 – 119
Red/green
4
120-255
Flashing red/green (incr. speed)
0 – 19
Normal operation
6
20 - 239
Strobe
