Manual / Bedienungsanleitung: DJ-150 G DMX
Version / Stand: 01/2010
Page / Seite 5 of / von 10
The address is the sum of all activated numbers, see the following example settings (the white
rectangle represents the position of the switch)
:
Addr
switch
addr
switch
1
65
17
113
The laser uses 8 DMX channels, so make sure that the next device uses an address that doesn’t
overlap with this range. E.g. when using address 1, make sure the next device uses at least address
number 9.
Channel
Value
Function
0 – 63
Sound mode
64 – 127
DMX mode
128 – 191
Automatic mode
1
192 – 255
Laser off
2
0 - 255
Patterns / animations
3
0 - 255
4
0 - 255
Line speed
5
0 - 255
Point speed
6
0 - 255
X-position
7
0 - 255
Y-position
8
0..255
Size
Please note, that not all effect channels work with every pattern.
E.g. you can’t change
position with dynamic patterns, or move a vertical line in y direction, etc.
Maintenance / cleaning
Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing the 2 upper screws on one side panel (one front and one back), then
bend side panel outward and slide out the top. Remove any deposits of dust, especially at the fan.
Check for condensed fog fluid inside. If so, clean and rearrange the position of laser and/or hazer.
Mirrors need cleaning when a “halo” is noticeable around the beam or an unusual high amount of
diffuse light can be seen inside the device.
Clean the mirrors with window cleaner and a paper towel.
Never look directly into the light source. Always disconnect from the mains when the
device is not in use or before cleaning it.
