Manual: Club Series CS-2000RGB NET
page 9 / 22
8. The
Network mode
:
Use the LAN interface at the device to connect it with a network.
Important:
If you want to use a lasershow software, make sure that there is no firewall which blocks net-
work traffic between your computer and the laser projector. The firewall has to be configured
to grant network access to the lasershow software. If the network connection does not work,
try to temporarily disable the firewall. If this helps, you can create a matching rule and re-
activate the firewall. Whenever the DIP switch settings for the network mode are changed (for
example, change static IP address or switch from DHCP to AutoIP mode), the ILDA interface
(resp. the laser projector) has to be restarted (switch power off and on).
9. The
DHCP mode
:
Dip switch setting
switch
1
2
3
4
5
6
7
8
9
10
On (1) / Off (0) 0
0
0
0
0
0
0
0
0
0
In this mode, the IP address is provided by a DHCP server. Therefore, a DHCP server has to be
available in the network. For example, this could be a cheap 100MBit network router with
integrated DHCP server.
10. The
AutoIP
:
Dip switch setting
switch
1
2
3
4
5
6
7
8
9
10
On (1) / Off (0) 0
0
0
0
0
1
0
0
0
0
In this mode, the IP address is negotiated automatically without the need for a DHCP server. A
Windows computer with enabled AutoIP is necessary to use this feature. In Windows 7, AutoIP
is enabled by default. In Windows XP, it has to be enabled manually. In any case, you should
check your computers configuration if AutoIP is available.
