Manual: BeamBar Series
page 7 / 29
8. Operation
1. Connect the power cable to the device and then to the mains
2. Insert key and turn it ‚ON‘
3. Please make sure, that the Interlock connector is inserted
4. Select mode:
•
Your device runs in
auto mode
:
•
Your device runs in
music mode
:
Adjust the music-sensitivity with the trim pot at the rear side of the device.
•
Use the
Master-Slave-Mode
:
To use the daisy chain mode, connect two (or more) laser projectors of the same series
via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 (DMX in) ...etc.
If you use the master projector in music mode or in auto mode, set all DIP switches of
every slave projector to off.
If you use the master projector in DMX mode, set DIP switch 1 of every slave projector to
on and every other DIP switch (2-10) to off.
•
Your device runs in
DMX mode
if ‘10‘ is switched off:
Set the DMX address
Connect a DMX controller to operate the laser.
