Manual: FX Series
page 10 / 26
English
2.4. MASTER-SLAVE
This laser is Master-Slave capable. This means that the Master laser system can hand on a
control signal to one or more Slave lasers, so all do the same.
Master-Slave only works with lasers of the same product series of the same product genera-
tion.
A: Link lasers with DMX cable
To use Master-Slave operation, link the Master with the Slave lasers with DMX cables. Make
sure to use the „DMX out“ port on the Master and the „DMX in“ on the Slave lasers. If several
Slave lasers are used, link the first one to the Master laser and daisy-chain the control signal
from the first Slave laser to the second etc..
B: Establish link to Slave lasers
The Slave units must be set to SLAVE („SLAV“) mode.
C: Activate Master Laser
The Master laser needs to be set as control source. To do that simply select „A001“ by naviga-
ting with the „Up“ / „Down“ buttons. Confirm with „Enter“.
D: Set Auto mode on Master laser
To use the Master-Slave operation: set the Master to Auto mode (2.2.).