Remove the lens form the lens holder. Place a piece of tape on the bottom of the Air Nozzle.
Make sure you remove the tape from the side of the carriage and fire for 1 second.
Remove the Nozzle from the bottom of the Lens Carriage. The burn mark should be near the center
of the impression of the air nozzle opening. Remove Air Nozzle for inspection
Looking through the top of the lens carriage
will not
give you an accurate location.
You will need to adjust mirror 1 to move the beam to the center. Once completed re-check P1-P4
once more. Any adjustments at this point should be quite minor.
Remember to always wear safety glasses while doing any open beam tests.
Burn Mark in Center of Nozzle
8
No Lens - Tape on Nozzle
After Mirror 1 Adjustment
Burn Mark Off Center
To adjust mirror 1 you need to open up access panel on the left side of the machine. In addition the
rear bottom back panel will need to be opened and the black box at the end of the laser needs to
be removed. Set the Pipe carefully on top of Mirror 1.
Mirror 1 as viewed from left side
lower access panel removed.