LaserLiner SuperPlane-Laser 3D, Operating Instructions Manual

Page: 8 / 104

08
LASER LASER LASER LASER
2
3
LASER LASER LASER LASER
EN
A1
A2
2.
1.
A3
A2
A2
A1
4.
3.
A3
A2
<
3,5 mm / 10 m = OK
Preparing the calibration check:
It is possible for you to check the calibration of the laser. To do this, position the device midway
between 2 walls, which must be at least 5 metres apart. Do this by turning the unit on, thus
releasing the transport restraint (cross laser on). Please use a tripod.
1. Mark point A1 on the wall.
2. Turn the device through 180° and mark
point A2. You now have a horizontal
reference between points A1 and A2.
Performing the calibration check:
3. Position the device as near as possible
to the wall at the height of point A1.
4.
Turn the device through 180° and
mark point A3. The difference between
points A2 and A3 is the tolerance.
Slope mode
Do not release the transport restraint, set slide switch (2) to "OFF" and switch on slope mode by pressing
and holding (3 seconds) button 5. Select the laser with the selector button (5). Sloping planes and tilts
can now be measured. In this mode, the laser lines no longer align automatically. This is signalised by the
laser lines flashing.
The transport restraint must be released for horizontal and vertical levelling. The laser lines flash
when the device is outside the automatic levelling range of 3°. Position the device such that it is
within the levelling range.
!
Horizontal and vertical levelling
Release the transport restraint, set slide switch (2) to "ON". The horizontal laser line appears.
The laser lines can be switched individually with the selection button.