LaserLiner AirBreeze 360, Manual, Page: 19 / 64

19
AirBreeze 360UV
c
d
a b
e
Changing the filter
6
1. A flashing Display button (13) indicates the filter is due
for replacement.
2. Switch off the air purifier and disconnect from the mains.
3. Remove the filter cover by pulling the tabs on the top (a + b).
4. Remove the pre-filter, the HEPA13 filter, and the activated
carbon filter in that order by pulling the tabs (d) provided
for this purpose.
5. Remove all packaging from the new filter before installing.
6. Fit the activated carbon filter, HEPA13 filter, and pre-filter (c).
Make sure the pre-filter is firmly seated at all six locking
points.
7. Refit the filter cover in the lower openings. Push the filter
cover carefully forwards into the locking points until is if
firmly seated (e).
1. Put the air purifier on a flat surface and remove all
packaging.
2. Remove the filter cover by pulling the tabs on the top (a + b).
3. Remove the pre-filter, the HEPA13 filter, and the activated
carbon filter in that order by pulling the tabs (d) provided
for this purpose.
4. Remove all packaging from the filter.
5. Refit the activated carbon filter, HEPA13 filter, and pre-filter
(c). Make sure the pre-filter is firmly seated at all six locking
points.
6. Refit the filter cover in the lower openings. Push the filter
cover carefully forwards into the locking points until is if
firmly seated (e).
Fitting the filters before the device is used
for the first time
5
PM 2.5 0 ~ 50 μg/m 3 50 ~ 100 μg/m 3 100 ~ 150 μg/m 3 150 μg/m 3 ~
Coloured indicator blue green purple red
Status perfect good normal poor
EN