9
Combinations of less than 3 buttons are also accepted. To program the “secret remote code” , proceed
as follows:
1)
Disarm the alarm system.
2)
Turn the ignition key ON.
3)
Press and hold button
C
of a functioning remote control.
4)
Turn the ignition key OFF whilst maintaining the activation of button
C
on the remote control. The
LED mounted on the motorcycle will illuminate.
5)
Release button
C
of the remote control.
6)
Enter the desired sequence of buttons for the secret code. The sequence can be composed by a
combination of three buttons of the remote control; each button can be pressed a maxium of 15 times.
The LED will switch OFF each time a button is pressed.
7)
After entering your coded sequence, turn the ignition key ON to exit the procedure.
Example 1:
C
button pushed 5 times +
A
button pushed 1 time +
B
button pushed 3 times.
Example 2:
C
button pushed 3 times +
B
button pushed 2 time +
C
button pushed 1 time.
Example 3:
C
button pushed 5 times .
NOTE:
-
The “secret code” sequence can be removed by executing the above procedure untill point 5;
afterwards turn the ignition key ON to exit.
-
To disarm the alarm during an alarm condition, firstly press any one of the 3 buttons on the remote
control (this will stop the siren sounding but not disarm the alarm), then enter your coded sequence.
-
If you forget your secret code, disarm the alarm with your emergency pin code, after you disarm
the alarm, the alarm will automatically enter remote programming. Reprogramming all remote
controls will reset the system to a single press of button
A
for disarming.
Number of presses
Button ” “
Button ” “
Button ” “
