LB Pinto 400 V3
29/13
?
TP ERR (Twisted Pair error – red)
ON when data error occurs on the UTP interface.
?
TP Data Valid – green
Flashes when the network packet being received on the UTP port is valid.
?
FO Data Valid – green
Flashes when the network packet being received on the laser interface is
valid.
?
RX Level OK – green
Indicates that the unit is receiving the amount of energy required to establish
the wireless optical link.
?
Received Signal Level (consists of ten green LED’s)
The LED’s indicate the received signal level. With one LED ON the system
already works at full speed, ten LED’s represents optimal signal strength.
?
Saturation – red
Indicates that the incoming laser light is too strong. Error free transmission
can not be guaranteed until this indicator is ON. Adjustment of the distance
alignment screw or increase of the beam divergence is necessary.
?
Install
Only for installation purposes. The light of the LED can be adjusted
JP201
JP200
JP201: (From the left)
Pin 1
AGC
Pin 2
GND
Pin 3
AGC/10
Do not short the pins only
for measurement
JP 200 (From the left)
Pin1-pin2
Install set to
125 µW
Pin 2-pin3
Install set to
25 µW
Summary of Contents for LB Pinto E1
Page 28: ...LB Pinto 400 V3 29 28...
Page 29: ...LB Pinto 400 V3 29 29...
