BLU-BD3000 User Manual
16 |
P a g e
NOTE: Only connect the LAN port of the player to an Ethernet port that supports 10BASE-T
or 100BASE-TX. Connecting to any other ports or jacks, such as a phone jack, can damage
the player.
Connecting a USB device
Requires a USB Flash drive or an external USB HDD (not included).
Insert the USB drive (or cable) into the USB port on the front of the player.
If the drive is to be used for BD-Live™ content it is accessed through the main menu of the
Blu-ray discs when played.
To access the content of the USB device for playback please see the Media Center section
later in this manual (See page 39)
NOTE: The USB ports are rated to provide a maximum of 5V, 500mA power to the USB drive.
It is sufficient for all USB thumb drives and flash memory card readers, but may not be
sufficient for USB hard disks. It is recommended that you use a USB hard disk with an
external power supply.
This unit supports “USB Mass Storage Class Bulk-Only Transport” devices only. Most USB
thumbs drives, portable hard disk drives and card readers conform to this device class. Other
USB devices such as MP3 players, digital cameras, and mobile phones may not be
compatible.
Supported USB drives must be formatted with the FAT (File Allocation Table) or FAT32 file
system. Drives formatted with NTFS file system supported as read only and cannot be used
for BD-Live.
In some cases, an incompatible USB device may cause the player to stop responding. If this
occurs simply turn off the power, remove the USB device, and turn the player back on.
The player accesses the USB drive in read and write mode. In order to minimize the risk of
data corruption, it is recommended that you only unplug the USB device when playback is
completely stopped.
