background image

6

www.lasertools.co.uk

Instructions

WARNING: 

Remove battery pack before any cleaning or maintenance is carried out.

• Refer to specific instructions included with battery and battery charger for details of fitting 
the battery pack to the tool and charging method.
• Refer to Figure 1: Ensure the Forward / Reverse selector (

3

) is in the centre LOCK position, 

before inserting the required screwdriver bit into the quick-release bit holder.
• Pull the collet on the quick-release bit holder forward (away from the tool) and insert the bit 
holder and bit. Then pull the inserted bit holder forward to lock in place.
• Only use quick-chuck type bits or bit holder. Do not use standard bits without the suitable 
quick-chuck holder.
• Note: In impact mode, use with suitable impact-grade bits only.
• Set the Forward / Reverse selector (

3

) to the desired function.

• Set the desired torque setting by pressing the torque selector button (

5

). There are four 

torque settings:

1. Low.
2. Medium.
3. High.
4. Intelligent adjustment control (tool adjusts speed to suit the torque required).

• Squeeze the trigger to start the screwdriver; further pressure will increase the speed 
subject to the selected torque setting.
• The LED worklight (

4

) lights up and shines onto the job when the trigger is depressed. It 

stays on for approximately 4-6 seconds after the trigger is released. 
• When finished, remove the bit holder by pulling the collet on the quick-release bit holder 
forward (away from the tool) to release.
• The tool features overload and overheating protection. Power to the motor will be cut off 
to extend tool and battery life if the tool is overloaded (draws an abnormally high current) or 
overheats. Stop the condition that has caused the overload, or let the tool cool down before 
restarting. If overheating, clean the tool using a dry cloth and soft brush. Then use clean, dry 
compressed air to blow through the air vents.

Reviews: