Page 14 - Laser Technology, Inc. LTI 20/20 TruSpeed Metric User’s Manual 3rd Edition
Copyright (c)[2013] Laser Technology, Inc. All rights reserved. Unauthorized duplication, in whole or in part, is strictly prohibited
Adjusting the Aiming Reticle's Intensity
The in-scope aiming reticle has eight intensity settings from DIM (01) to
BRIGHT (08).
1. Press the
button. The display should
look similar to Figure #12. The factory
default setting is "br 05" as shown in the
figure.
2. Press the
button until the desired
setting is achieved. It's easy to get the
desired setting if you look through the
scope while making the adjustment.
Each time you press the button,
the "br xx" value increases by 1.
If you press the button while
"br 08" is displayed, you will
see "br 01" next.
3. Press the TRIGGER to return to the
measurement mode that was most
recently active.
Restoring Factory Default Settings
1. Verify that the TruSpeed is powered ON.
2. Simultaneously, press and hold the
button and the
button until
“dEF CLEAr” appears on the screen.
The display should look similar to
Figure #13.
3. Release both buttons. The Speed Mode will
be active and the Speed Measurement
Screen will be displayed.
Powering OFF the instrument does not change this setting. The next
time the instrument is powered ON, the setting will be the same.
Figure #12
Figure #13
