2
Instruction Manual
Bench Press with Electric Pump “ECE01113-CE”
INDEX
1. BEFORE USING THE EQUIPMENT........................2
2. TECHNICAL FEATURES ..........................................3
3. ESSENTIAL SAFETY REQUIREMENTS ...............4
3.1 GENERAL CONSIDERATIONS.
3.2 COMMANDS SECURITY.
3.3 PROTECTION DEVICES AGAINST MECHANICALL RISKS.
3.4 PROTECTION DEVICES AGAINST OTHERS RISKS.
3.5 SECURITY IN MAINTENANCE.
3.6 INDICATIONS.
4. TRANSPORT AND INSTALLATION .......................4-5
4.1 START UP
5. MAINTENANCE AND DAMAGES ...........................5-6
6. WARRANTY.................................................................6
7. DECLARATION OF CONFORMITY .......................7
ANNEX
GENERAL DRAWING
1. BEFORE USING THE EQUIPMENT.
Before unpacking check for:
1.
Oil leaks.
2.
Signs of corrosion.
3.
Damages in the hydraulic cylinder and the hydraulic line.
4.
Damage sin the frames and accessories of the cylinder.
5.
Damaged screws or connections.
6.
Bad connection of the accessories.
If any anomaly it is detected, avoid the use of it and place it in a safe and far location until be repaired by an authorized service dealer.
Familiarize the operators with the equipment before using it, and read and follow the instructions and recommendations included in the packaging.
Any improper use, do not observed in this manual, and the omission of the same, may cause personal injuries and material damages which LARZEP, S.A. will not be
responsible.
Do not work with the equipment near of the flames, explosives, warm intense sources, or any other source which may produce fire, or which may produce damages
in the equipment. The hydraulic equipment must not be exposed to temperatures greatest than 60ºC, as on use as on storage.
When a place to the press is located, make sure that there is in a stable surface, is to say, that all base of the press, be supported. If any doubts exist about this
question, it is recommended that distribute the weight in a bigger area, placing a steel shell behind the press’s base.
Store the press when the piston is fully retracted. It is recommended protecting the cylinder with a plastic, or place the press in a clean area, for not damaging the
components and for keeping the press correctly storage.
2. TECHNICAL FEATURES.
HYDRAULIC CYLINDER
MODEL
KC01113
Push capacity (ton)
10 ton
Maximum pressure (Kg/cm
)
700 Kg/cm
Stroke (mm)
130 mm
Effective area (cm
)
15.9 cm
Oil capacity (cm³)
214.7 cm³
Approach speed (mm/sg)
31 mm/sg
Working advance speed (mm/sg)
5.8 mm/sg
If you are purchasing a cylinder or pump, for the use of it in the press, make sure that you are using a correct combination before assembling it.
We recommended, asking for advice in this questions to our technicians.
Never use equipment suspected to be in poor conditions.
Do not loose the instruction manual.
Never locate the press or store in a place where the children could access to it.