3
Instruction Manual
Hydraulic Cutter “CK0216”
PERFORMANCE
Minimum diameter: 5 mm
CHAIN
3. START UP.
1.
Assemble the complete system, and make sure about the perfect fitting of pump, hose, coupler and tool. This is a double acting tool, so both couplers must
be connected.
2.
Make sure about the knowledge of pump chosen and who it work.
3.
Test the circuit, pumping oil into the tool. Check the tool at maximum pressure, working the piston against the limit of stroke and return the blade. Repeat
this operation to get used to the circuit. The maximum operating pressure of the tool is 700 bar. Do never exceed under any circumstance this limit.
4.
Insert the chain link or bar in the gap between blades (max. 30 mm.).
5.
Centre the material to be cut in the gap and look for the alignment with the tool.
6.
Actuate the pump until the material is broken. Return the movable blade by switching the valve to return position.
4. MAINTENANCE.
REPLACEMENT OF BLADES
Fixed blade:
Loosen the screw (10), and push the blade with a nail through the head hole. Remove the damaged blade, put a new one and tighten the screw (10).
Movable blade:
Dismantle the screws (8), at the both side, and unscrew the body from the head.
Next step, dismantle the piston, and unscrew the bolt (9), to get the blade free.
Put a new one and proceed opposite way to mount back again, controlling the position of the flat side of the piston.
The screws (8) work like the piston guide. Lock the screws leaving an enough gap for a well work of the spring.
REPLACEMENT OF SEALS
After dismantle the piston, unscrew the stop ring (14), and pull out the piston from the body. Replace the seal and segment for the new ones. Do not use sharp edged
tools. Use spare parts from LARZEP.
Take this opportunity to change all the seals in case they look damaged.
To mount back again, proceed opposite way.
5. WARRANTY.
LARZEP, S.A.
guarantees its products against all design and manufacturing defects for the durations of two years from the date of purchase. This guarantee does not
include the ordinary wear of both metal and non-metal parts, abuse, using the equipment beyond its rated capacity and any wear or damage incurred as a result of
using a hydraulic fluid which is not recommended by
LARZEP, S.A.
Please note that if the equipment is disassembled or serviced by anyone other than an authorized service dealer or by
LARZEP, S.A
., this guarantee is rendered null
and void.
In the event of a warranty claim, return the equipment, to
LARZEP, S.A
. or the authorized dealer which sold you the hydraulic equipment,
LARZEP, S.A
. will
repair or replace the faulty equipment, whichever is deemed most appropriate.
LARZEP, S.A.
shall not be held liable for any consequential damages or losses,
which may occur as a result of faulty equipment
MODEL
CK0216
Strength kg/mm
Diameter mm
70
19
100
15
140
13
160
11
MODEL
CK0216
Strength
Standard
Chain Diameter max. mm
28-43-50
ASTM 413 - DIN 5684
19
60-80
DIN 5685 - DIN 764
14
