1660K096G
Page 2 of 25
Introduction to the DC-10ST
The DC-10ST display is presented as an easy-to use thermometer adjusted and calibrated at factory.
The main window shows the current temperature with 0,1ºC resolution. The main window can be set to turn
on and turn off at the time set by user and is adjustable in bri
ghtness (see “Parameters of the display” in this
manual). There are add-on functions depending on the display. These functions are fully compatible and can
be combined with each other:
If the display includes option NE (Ethernet connectivity), this display hosts a web site where the user
can see the status of the display and configure it. This function allows the display to be used as a server for
other displays to synchronize the hour through the Ethernet, as well as updating its time and date through a
SNTP server. User can configure and request the time through TCP/IP commands. The default IP is
192.165.1.100
. See “Ethernet option” in this manual for more information.
If the display includes option X (RS-485 connectivity), this display can be configured as a RS.485
server/client. This means that the display can connect with other displays to sync between them, as well as
the user communication through commands. If the display also includes the Ethernet option, the display can
work as a bridge between both options. See “RS-485 option” for more information
Installation of the DC-10ST
4 fixation
points
ºC
The DC-10ST displays can be fixed to the wall in two ways:
1
– Hanged. Place 2 of the supplied plug at 314mm from one to the other. Insert the screws leaving
their head outside for 4mm. Hang the display using the upper-side zig-zag.
2
– Screwed. Remove the methacrylate cover. Place the 4 supplied plugs at the distance showed in
the drawing. Place the 2 upper screws, leaving their head outside for 4 mm. Hang the display using the upper-
side zig-zag. Place the lower screws Tighten all the screws. Replace the methacrylate cover.
TECHNICAL MANUAL DC-10ST
Thermometer with RS-485 and Ethernet function
