ShortYellow
Clip
b) BOTTOM CLOSER
;
Close and latch the
door. Assemble the
bottom closer (the
closer with the Touch’n
Hold button), door bracket and long pin
together with the arrow on the door bracket,
per Fig.5, pointing toward the hinge side of the
door. Attach to the bottom jamb bracket using
the short pin and
short yellow plastic spacer
clip
, per Fig.6.
(NOTE: Short yellow plastic
spacer clip must be used to ensure proper
operation and function).
Hold the assembly
level and mark the front mounting hole location
of the door bracket. Drill 1/8” starter hole.
Caution: Do not drill through the outside of the door.
Attach the door bracket using a #10 x 5/8” screw. Remove the long pin, short
pin, closer and yellow plastic clip. Discard the yellow clip. Drill 1/8” starter hole through the exposed hole in the door bracket and fasten
using #10 x 5/8” screw. Reattach the closer using the long pin, with o-ring to hold in place, and short pin.
Note: If you need to adjust the horizontal positioning do not drill additional holes.
There are four additional adjusting positions. This will affect the closing force as the door closes through the last 12 inches of operation.
This can be done by reversing the arrow direction on the door brackets and changing the hole that is used on the closer.
More Closing Force
:
Arrow on door bracket is
pointed away from the
hinge side of door and
closer is attached to door
bracket using the front
hole.
Standard Installation
:
Arrow on door bracket is
pointed toward the hinge
side of door and closer is
attached to door bracket
using the front hole.
Less Closing Force
:
Arrow on door bracket is
pointed away from the
hinge side of door and
closer is attached to
door bracket using the
rear hole.
Least Amount of
Closing Force
:
Arrow on door bracket is
pointed toward the hinge
side of door and closer is
attached to door bracket
using the rear hole.
Operation and adjusting instructions:
To hold the door open:
Just press the Touch’n Hold button on the closer.
To close:
Push the door open slightly and release.
To adjust closing speed:
The door closers are adjusted at the factory for the comfort zone, to close the door in 4-5 seconds.
This setting may be adjusted from the thumbscrew shown in Fig. 7.
Caution: Do not use a power
tool to install or adjust the screw.
It is recommended to adjust closers individually (with the other closer disconnected). Turn
clockwise to turn down the speed of the door.
Slower
Faster
Arrow
Fig. 7
Fig. 5
Fig. 6
Touch’nHoldButton
BottomofDoor
ShortYellowClip
