MOUNTING THE SCREEN CASSETTE
On a recess installation, the
Screen Cassette Assembly
will be fastened to the
inside top with
Recess Mount Clips
. Measure how deep into the frame you wish
the
Cassette Assembly
to be installed. Using the
#8 x 3/4”(19mm) Phillips Pan
Head Screws
, attach the
Mount Clips
to the top approximately 6” in from each
side. For wider openings, space any remaining clips evenly along the top.
Make certain that the
Set Screws
are facing the front
(1A)
. With clips screwed
to the jamb securely, position the
Screen Casette Assembly
so that the back
flanges of the
Mount Clips
fit into the groove at the top and back of the
Cassette
Assembly
(1B)
. Then bring the front of the
Casette
up, so that the top of the
Cassette Assembly
is flat against the clips. With the
Cassette Assembly
positioned
correctly within the opening, tighten the
Mount Clip Set Screws
so that the
Cassette Assembly
is secure and straight within the opening
(1C)
.
INSTALLING THE SIDE GUIDE RAILS
Slide the top end of both
Side Guide Rails
onto the nylon tabs that protrude from
the
End Caps
of the
Screen Cassette Assembly
with the shorter pile to the inside
and with the plastic end cap toward the sill
(2A).
(
NOTE:
make sure the left and
right edges of the
Screen and Screen Pull Bar
are inside the
Side Guide Rails
).
Attach the
Side Guide Rail
s to the opening using
#8 x 3/4”(19mm) Phillips Pan
Head Screws (2B)
.
MOTORIZED SCREENS:
If you purchased a motorized screen you will need to
set the limits (the start and stop points of the screen) once the screen is
installed. Please see the separate operating instructions that accompanied your
remote control.
SIDE VIEW
OUTSIDE
DOOR HEAD
INSIDE
D
C
SET SCREW
6"
A
C
C
A
B
B
D
D
D
D
D
D
C
C
A
B
B
D
A
D
PAGE 2
1A
1B
1C
2A
2B
Inside
Outside
Shorter Pile
GrandVue
RECESS INSTALLATION
