WAL-TL-3XTL-C-SOL-100C
Solar Powered LED Signal Stack Light
Red, Yellow, Green -
100' 12/
4
SOOW Cord
Instruction Manual
Thank you for your purchase of the Larson Electronics WAL-TL-3XTL-C-SOL-100C Solar Powered LED Signal Stack Light.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
•
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
RELEVANT LOCAL BUILDING CODES.
•
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF
FIXTURE'S
ELECTRICAL
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
•
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE
FIXTURE'S
RATED VOLTAGE.
•
TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
The WAL-TL-3XTL-C-SOL-100C Solar Powered LED Signal Stack Light from Larson Electronics is designed for routing
traffic in industrial refueling stations and safety notifications. This two-watt unit emits red, amber and green colors,
while operating on 24V AC/DC. The LED stack light is equipped with a waterproof solar panel and 100` of 12/4 SOOW
cable between the panel and the light fixture.
INSTALLATION
MOUNTING SOLAR PANEL
This solar panel includes a permanent mounting system that allows for
mounting to square/round poles or flat surfaces such as a wall or post
shown in figure below.
Position the solar panel in a location that receives the maximum amount of
sunlight throughout the day. This may need adjusted depending on the
season. With pole mounting, loosen the adjustment bolts to fit solar panel
onto pole. Once mounted, tighten bolts snug to secure panel to pole. For
surface mounting, remove additional plate and use the existing mounting
holes to mount directly to surface.
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
MOUNTING STACK LIGHT
We strongly encourage a licensed electrician install this product,
in all locations, especially in outdoor areas where weatherproofing
may be required. Follow all applicable building and electrical code
when installing.
The stack light is designed to be mounted to the top of a threaded pipe
using the coupler on the bottom of the light. Feed the wiring through
the pipe you are mounting the light to, and thread the coupler onto the
pipe. Complete wiring connections utilizing the provided connectors,
each wire is labeled with it's corresponding connection. Once
connections are complete, thread the light onto the top of the coupler.
Installation is now complete.
