Rev 0418
6.
Feed the wiring back through the plate and spoiler and
reconnect the harness to the spoiler
.
7.
Push the plastic clips from the taillight assembly back
through the holes in the spoiler to lock taillight back in
place. Replace the 4 screws to secure the plate and
taillight to the spoiler. Tighten screws securely, but be
careful not to over-tighten or cross-thread!
Note:
If a screw won’t tighten, realign the mount. Make
sure the holes line up before tightening screws.
Complete!
Your new mount is now installed!
Check to ensure everything is secure and that your tail
light is working. Attach your device to the steel
mounting plate via magnet (if applicable) or permanent
mount to the aluminum plate. Run wires to a
power source.
Note:
When removing an attached magnetic device from
the
magnetic
mounting plate
models
, do not force the device off
the front causing the mount to bend as this could cause strain to
the mount and tail light. Instead, remove the magnetic device from
the back of the mount, up and away from you.
7
6
