Class I, Div. I Explosion Proof Horn - Industrial Siren
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
directly to surface.
Keep in mind, the horn is connected to the panel by
15ft. of SOOW cord. Be sure the horn is connected
to the solar panel and that the deutsch connections
are tight. Run the cord and mount the horn nearby
using the two predrilled mounting holes toward the
base. If magnetic mounting, attach horn to solid
metal surface. The horn comes with user selected
permanent or magnetic mount and color from
factory.
HORN WIRING DIAGRAM
OPERATION
The solar panel comes preconfigured with user the
selected panel operation option..
you wish the lamp to become operative, slowly
rotate the control in a clockwise direction until a
point is reached where the lamp illuminates. Leave
the control set at this point. At this position, the unit
should become operative at approximately the
same level of darkness each evening. Observe the
operation of the unit. If the unit is starting to operate
too early (e.g. when it is quite light), adjust the
control slightly anti-clockwise. If the unit starts to
operate too late (e.g. dusk), adjust the control
slightly clockwise. Continue to adjust until the unit
operates as desired.
.
ON/OFF SWITCH (-On.Off)
The on/off switch powers the beacon on or off with
the flip of a switch. The power switch is located on
the solar panel for operating the beacon at a
moment’s notice.
Remove the mounting plate from the light and mark
holes on surface. Drill through holes for bolts or
screws to fit through. Attach beacon to mount on
and twist to secure.
After the batteries have been fully charged, the
beacon will illuminate with configured panel
operation listed.
The solar panel surface must be kept clean to
collect sunlight effectively.
CHARGING
With up to 5 hours of daily sunlight, this beacon is
designed to function 15 hours. Ensure there are no
obstructions that could result in little to no sun
reaching the panels.
MAINTENANCE
If the lens or solar panel becomes dirty, wipe down
with a mild soap and water solution.
Keep snow and debris clear of the solar panel so
the batteries can charge. If the panels are covered
by snow or debris for an extended period of time,
DEUTSCH
CONNECTOR