Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
1.
Remove the 4 screws holding the top cover in place on the rear of the main housing. This is the
squared section. The 4 screws can be seen when you turn the light upside down. Once the top
cover is removed, you will see the battery pack.
2.
The battery pack consists of 6 cells welded together. A single Molex style connector brings
power from the battery to the LED bulb. Disconnect this connector and remove the battery pack
as a whole. Double sided tape secures the battery pack. Be sure that if the tape has lost its
adhesion qualities that you replace it when replacing the battery pack.
3.
Replace the battery pack (part number RL-85-BATT), replace tape if required, reconnect the
power connector from the battery to the light, and replace the top cover. Secure the 4 top cover
screws.
4.
Lithium ion batteries have a very long life. Users should not have to replace the battery pack
often.
MOUNTING
1.
These units are handheld via the pistol grip handle, but can be mounted via the 3/8-16” brass
nut fastener embedded into the base of the handle.
2.
We offer a 100lb magnetic base (MM-2) for magnetic mounting, and a permanent mounting
plate with swiveling and tilting bracket (PMB-4X4) for permanent mounting.
