LEDWP-600E-M-E2E-20C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
ASSEMBLY
Use the table below for assembling the hardware including the glare shield.
Note:
Some hardware shown may not be included depending on final product configuration.
DAISY CHAIN
Daisy chain multiple fixtures by connecting ends. Plug the male cord
cap from next lamp to the female cord cap of first lamp and repeat for
each additional lamp. Plug the first lamp in the daisy chain to a power
outlet to illuminate all attached lamps.
MAINTENANCE
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
Disconnect power running to the lamp and be sure the fixture is cool to the touch.
Use a non-abrasive glass cleaning solution to clean the lens.
Note:
It is not necessary to open the fixture and clean or touch the LED
’s.
Should further information not covered by these instructions be required, please contact Larson Electronics at
1-800-369-6671 for further assistance.
CORD GRIP
MOUNT SCREW
ASSEMBLED UNIT w/Glare Shield
