LEDWP-500-M-20C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
2
of
2
MOUNTING
The LED includes all necessary hardware for installing the mounting bracket
.
Follow the guideline below to
properly assemble and install the unit.
The light includes the LED light
and
trunnion mount
.
Some models may omit hardware depending on selected
options.
1.
Begin by choosing a location to install the fixture.
This LED is waterproof, vapor proof, and built
to resist
the damaging effects of an outdoor environment. This fixture should not be used in areas with no
ventilation or
extreme ambient temperatures.
2.
Affix the mount to your chosen surface.
There are pre
-
drilled holes on the trunnion bracket for mounting and
for the cord grip. These can be used any way suitable for the location. Plan a way for wiring to connect such as
using a separate junction box and utilize the cord grip where necessary.
3.
Attach lamp.
The trunnion mount can be attached to the lamp in two locations, the lower area or middle area
on the back of the wall pack.
The fixture can be placed in any direction
and is attached using 2 screws and 2
washers.
WIRING
We strongly encourage a licensed electrician install this product, especially in outdoor locations where
weatherproofing may be required.
Universal voltage driver permits operation at 110V - 277V AC, 50 or 60Hz
.
Warning: Check product label for correct input voltage!
Attach supply line wires to the appropriate light
fixture wires as shown in the diagram
Secure each pair with a wire nut according to the
diagram. Utilize a junction box or similar device and
take precautionary steps for weatherproofing all
connections if installed in a location where water may
come in contact with the unit. Ensure the unit is
properly grounded.
MAINTENANCE
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
•
Disconnect power running to the lamp and be sure the fixture is cool to the touch.
•
Use a non-abrasive glass cleaning solution to clean the lens.
Note: It is not necessary to open the fixture and clean or touch the LED’s.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
LEDWP-500-M-20C
is designed to provide years of reliable performance. Should the need for replacement parts
arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.