LEDFUL10-DL-RGBW-PM-KT.3X
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
3
75W Underwater Dock Light Package
(3) LED Lights - Control Box - 10-30V DC - IP68 Compliant
Instruction Manual
Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this
instruction sheet.
Read carefully before operating. Retain these instructions for future reference.
WARNING!
WARNING: RISK OF ELECTRIC SHOCK
Use only in bodies of water, ponds and small decorative fountains where persons will immerse no more than their
hands and lower arms while the product is energized.
DO NOT use in water intended for swimming, wading, immersion, or bathing.
All installer completed cable connections must be located outside of bodies of water, pond or fountain.
Low voltage circuit must be supplied by a power unit marked as suitable for supplying submersible luminaires.
Power unit must be supplied by a circuit protected by a ground fault circuit interrupter (GFCI).
Maximum depth: 8 feet
All installer completed cable connections must be located outside of bodies of water, pond or fountain. Take
careful consideration of tidal shift if connections are completed under docks, or near waterline.
WARNING:
For your safety read and understand instructions before starting installation. Before attempting any
installation check your applicable electric code. This code sets the wiring standards and should be carefully studied before
starting.
Note:
All statements, technical information and recommendations contained herein are based on information and tests
conducted under typical intended use conditions and are not considered all inclusive, in accordance with "Terms and
Conditions of Sale", the purchaser should determine the suitability of the product for the intended use conditions and
assumes all risk and liability whatsoever in connection therewith.
IMPORTANT:
Read carefully before installing fixture. Retain for future reference.
APPLICATION:
Dock Lighting Systems are designed for outdoor wet locations, where moisture, dirt, saltwater may be
present. The
LEDFUL10-DL-RGBW-PM-KT.3X underwater dock lights are intended for full submersion in fresh and salt
water.
Listed models of Dock Lighting System can be operated at the following voltages:
100VAC
– 120VAC 50/60Hz
Underwater light Installation
Notes:
Pilings should be cleaned to remove hard growth and provide a stable base to install against.
Stainless Steel clamps are 60 inches long to provide enough length to wrap around a 12 inch square or 14 inch
diameter round piling.
It is helpful in tidal locations that this part of the installation be performed close to low tide.
1.
Slide l stainless steel clamp through slot in the back of the light housing. Wrap clamp around piling and feed free
end of clamp back through clamp latch and back through slot in light housing.
2.
Adjust so that light is approximately 6 - 12 inches below water line at a typical low tide for your area.
3.
Tension clamp by holding light with one hand and pulling cable with the other. It may help to pull the free end of
the clamp with pliers. Bend free end near fixture to prevent cable clamp from becoming unfastened. Excess cable
clamp material may be cut off.
