HL.RL-85-LED-36W-CPR-1227
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
POWER
The rechargeable HL.RL-85-LED-36W-CPR-1227 spotlight comes equipped
with a 7.4V 2600MA lithium battery and an inline transformer that steps down
120-277V AC to the low voltage required to run the light. A 120V or 240V wall
charger comes standard, as well as a vehicle charger that operates on
12-24V DC. This light has a work time of 2.5-3 hours on a single charge.
Recharging from a fully discharged state takes 3 hours.
The HL.RL-85-LED-36W-CPR-1227 features a unique charging function that
allows the spotlight to be charged while it is plugged into a power source and
while it is in use. The cord can be disconnected at any time from the power
supply to turn this unit into a rechargeable unit. Once the spotlight is
unplugged for portable use, it will offer operators an equivalent battery life to
however long it was plugged in for. For example, if the LED spotlight was
plugged in and being used for one hour, the battery would then have one hour
of portable use available. Once the battery dies, the HL.RL-85-LED-36W-
CPR-1227 can immediately be plugged back in for battery recharge while still
being able to be used as a normal spotlight during the recharging process.
The HL.RL-85-LED-36W-CPR-1227 super bright handheld 10 million candlepower spotlight from Larson Electronics is
lightweight, ultra rugged, and features a comfortable ergonomic design. This unit uses seven high output Cree LEDs and
an advanced reflector and lens configuration to generate 3,200 lumens with a beam reach of over 1,600 feet while
drawing only 36 watts of power. What sets this LED spotlight apart from other models is that it charges while it is plugged
into a power source even when it is in use. The cord can be detaached from the light by disconnecting it from the power
supply to use this light like a rechargeale unit. Operating on 120-277V AC standard wall voltage that is stepped down via
waterproof inline transformer to 12-24V DC, this IP67 rated waterproof spotlight is ideal for a wide variety of applications.
The HL.RL-85-LED-36W-CPR-1227 features a continual on/off switch that requires one press to stay on and another
press to turn off. This unit can be used while plugged in or it can be unplugged and used via battery operation.
DETACHABLE CORDS
•
The 12V coil cord is attached via a weatherproof 2-pin Deutsch connector.
•
Additional or replacement cords can be ordered from our website.
•
The cord is detachable by depressing the tab on the top of the connectors. This enables the operator to leave the cord
connected to the power source and remove to store the light.
*We offer 16 foot coil cords with a cigarette plug (C-16-CC-CP), 21 foot cords with ring terminals (C-21- RT), 16 foot
cords with battery clamps (C-16-BC), and 16 foot straight cords with cigarette plugs (C-16 CP).
DEUTSCH CONNECTOR
LENS
REFLECTOR
ASSEMBLY
ON/OFF
SWITCH
CHARGING PORT
QUICK DISCONNECT
DEUTSCH CONNECTOR
POWER
This general use LED spotlight is equipped with 20 feet of 16/3 chemical and abrasion resistant SOOW cord between the
light and transformer as well as an additional 3 feet extending from the transformer that is fitted with an industrial grade
cord cap for easy connection to common wall outlets. Plug options include standard 5-15 15 amp straight blade plug for
110V wall outlets with ground, standard 6-15 15 amp straight blade plug for 220-240V wall outlets with ground, NEMA
L5-15 15 amp twist lock plug for 125V twist lock outlets, NEMA L6-15 15 amp twist lock plug for 240V twist lock outlets,
British BS1363 13 amp fused 3-blade plug for United Kingdom outlets, or a two pin 16 amp rated Schuko plug with ground
contact and socket for European outlets up to 250V. Alternatively, we can provide flying leads with no plug for hard wire
applications or for operators who prefer to wire in user provided cord caps. Please choose pigtail option below for flying
leads with no plug.
MOUNTING
1.
These units are handheld via the pistol grip handle
