HL-85-HID-CPR
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
ASSEMBLY
WIRING
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at
12/24V DC
.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
Standard Cord Cap
This unit comes pre-wired from factory with the selected cord cap. Take
precautionary steps for weatherproofing all connections if installed in a
location where water may come in contact with the unit. All outdoor
installations and indoor installations near a wet location require the use of a
GFCI device for safety, according to the National Electrical Code® (NEC).
Ensure the unit is properly grounded.
Low Voltage DC
Connect power to power supply outputting low voltage between 9-42 Volts DC.
This variable voltage allows greater versatility without affecting light output. Ensure
deutsch connectors are properly connected (If applicable)
DETACHABLE CORDS
•
Cord is attached via a weatherproof 2-pin Deutsch connector.
•
The cord is detachable by depressing the tab on the top of the connectors. This enables the
operator to remove and store the light while leaving the cord connected to the power source.
•
Additional or replacement cords can be ordered from our website. Contact us or visit LarsonElectronics.com for more
information.
POWER
1.
The spotlight can be plugged into a cigarette plug socket, attached directly to
low voltage DC batteries, etc.
2.
Each unit is designed to work on 12-24 volts DC. This variable voltage allows
the light to be connected to consumer vehicles and other non-standard power
supplies such as military vehicles and heavy equipment.
PLEASE NOTE:
There is no difference in light output between voltages.
3.
Power transformers (DCP-11-DP) can be purchased through our website to run
this spotlight from household wall outlets.
-
LENS
REFLECTOR
-
ON/OFF
SWITCH
-
HANDLE
3/8” FASTENER
QUICK DISCONNECT
DEUTSCHE CONNECTOR
CIGARETTE PLUG
IN CONNECTOR
16FT COIL CORD
MOUNTING
1.
These units are handheld via the pistol grip handle, but can be mounted via
the 3/8-16" brass nut fastener embedded
into the base of the handle.
2.
We offer a 100LB magnetic base (MM-2) for magnetic mounting, and a
permanent mounting plate with swiveling and
tilting bracket (PMB-4X4) for
permanent mounting.
