HID-22-SL-480V
20 Inch High Intensity Light
1000 Watt or 1500 Watt Metal Halide - Flood Light - 480V
Instruction Manual
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE
HID-22-SL-480V
MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE
AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS
PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,
CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING:
MAKE SURE POWER IS TURNED
OFF
BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
RISK OF PERSONAL INJURY –
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
The HID-22-SL Metal Halide Light from Larson Electronics provides operators with the intensity and good color
rendering of a metal halide lamp in a unit that is safe for ground mounting and use in wet areas.
MOUNTING
HID-22-SL
is equipped with a rear mounted U-bracket for mounting the
light to flat surfaces, such as a wall or ceiling. Be sure the surface you
are mounting the light to is capable of supporting the load. Mounting
hardware not included. The U-bracket is pre-drilled with 2 holes for user
provided mounting hardware. The bracket is adjustable by loosening the
bolts holding it in place on either side of the box, tighten bolts back down
with bracket in desired position. The angle of the light is adjustable by
loosening the lock nut between the box and the light, swivel light into
desired position, tighten lock nut back down to hold in place.
WIRING
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required.
This unit is available in multiple voltages, specified when ordering. Be sure
source voltage matches the voltage your fixture is rated for.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the
applicable
diagram
to your chosen
voltage and cord option
. Utilize a junction box or similar device and take
precautionary steps for weatherproofing all connections if installed in a
location where water may come in contact with the unit. Ensure the unit is
properly grounded and that wiring is done according to all local and national
electrical/building codes.
This unit
may
also come
pre-wired from factory with the selected cord
cap.
Mate the cord cap with a compatible receptacle outputting the correct
voltage.
Take precautionary steps for weatherproofing all connections if
installed in a location where water may come in contact with the unit.
All outdoor installations and indoor installations near a wet location require
the use of a GFCI device for safety, according to the National Electrical
Code® (NEC). Ensure the unit is properly grounded.
Larson Electronics, LLC
Phone: (8
77
) 3
48
-
9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
