GVP-EMG-48-2L-LED
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the
diagram on the next page.
Secure each pair of wires according to the diagram. Utilize a junction box or similar device and take
precautionary steps for weatherproofing all connections if installed in a location where water may come in
contact with the unit. Ensure the unit is properly grounded and that wiring is done according to all local and national
electrical/building codes.
Low Voltage DC
Connect power to power supply outputting low voltage between
12
-
24
Volts DC. This variable voltage allows greater
versatility without affecting light output. Ensure deutsch connectors are properly connected (If applicable)
L
IGHT ASSEMBLY
1.
Turn off the power at the main fuse or breaker box.
2.
Thread wires through wire gland and back cover wire hole.
3.
Connect the wires to the wire terminal L to L, N to N then fasten the wire gland.
4.
Attach to the LED tubes to the lamp holder.
5.
Put the tube fixing board in the back cover, fixing poles through the board’s holes. Then turn around the head of
fixing poles 90° to fix the board to back cover.
6.
Use the lens and back cover clips to attach lens to back cover.
7.
Use the wall fixing clips to fix the light fixture to the wall.
8.
Turn on power at main fuse breaker box.