GSLEDIP6-C1D2
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
4
1.
Mount fixture in desired location using 1/4”
screws (not included).
2.
To position, loosen the bolt at the end
without the cord, adjust fixture to desired
angle, and re-tighten to hold
in place.
3.
Supply side of the cord must be terminated
with a listed cord connector complying with the
NEC/CEC requirements of the
installation.
The cord connector must be rated for use
with suitable cable of types SOW, STOOW,
STOW, SEOW,
SEOOW having a diameter
between 8.75mm/o.345” and 9.4mm/0.370”.
The listed cord connector must be installed
in
a listed box complying with the NEC/CEC
location requirements of the installation.
The cord connector and box
must be rated
to the environment of the installation. The
installation environment must not exceed
the Ingress
Protection IP65 rating of the
luminaire.
4.
Connect the lead wires from the cord to
the field supply wiring. The field wiring
terminations are to be
made following
acceptable practices as outlined by the
NEC/CEC for either the specific ordinary or
hazardous
locations as dictated by the
installation location.
5.
Energize luminaire.
INSTALLATION
Loosen bolt to adjust to
desired angle.
*DO NOT connect light to high-voltage. Do-ing so will cause permanent damage to fix- ture
and void warranty.
MOUNTING
The GSLEDIP6-C1D2 hazardous location LED light is constructed of extruded aluminum with a tough powder coat finish for
high strength and durability. The housing is IP54 rated, providing limited ingress protection against dusts, and l protection
against light water spray such as rain. This design is weather resistant, suitable for indoor or outdoor applications, and ideal
for areas where wetness or dusty conditions are commonly encountered.
The LEDs in this unit are Cree X-Lamp XR-E units that have been chosen for their high lumen per watt ratio and extreme
long life. These Cree LEDs provide over 90 lumens per watt output and have a 70% lumen retention at 50,000 hours, giving
them better efficiency and operational life than comparable LEDs. These fixtures are offered with a clear or frosted lens. The
frosted lens helps diffuse the light, providing a more even spread. The clear lens will provide no diffusion.
Mounting for this unit is provided by two standard adjustable end brackets that allow operators to mount the light to flat
surfaces and then adjust the light vertically for the best placement. The entire assembly weighs 0.7 lbs and measures 6.5
inches in length and 2.68 inches wide and 1.69" deep, making it ideal for mounting in areas where space is limited and a
low profile fixture more readily installed.