GL-2051GT
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
OPERATION OF GOLIGHT® RADIORAY®
1.
Using the remote control, turn on the light by depressing the on/off button.
2.
With the 4-way arrows on the remote control, rotate your light
to the desired location. Depending upon conditions, the wireless
remote may be
used up to 80 feet from the RadioRay.
3.
The speed of the light rotation can be controlled by depressing
the tortoise/hare button one time and by depressing it again
to restore the original
speed.
4.
The spotlight should not be turned on when the snap on lens
cover (rockguard) is attached. (Not applicapble for LED)
BATTERY INSTALLATION AND DISPOSAL
• Remove Battery Cover: remove the phillips head screw
securing the battery cover then remove the cover. With the
battery compartment now
exposed, insert batteries according
to correct polarity. Remove the batteries by gripping the
positive end of each battery and lifting.
For information regarding the proper disposal/recycling of the batteries contact Larson Electronics at (800) 369-6671
Use only 12v-A23 batteries in the Golight remote control
USAGE:
» This light is intended for off-road and utility use only
» This light is intended to be mounted outside the vehicle while
in use
» This light may only be disassembled and repaired by an
authorized representative
MISUSE:
» This light is not approved for road or highway use
» This light is not approved for underwater use
» This light is not approved for inverted mounting
» This light is not approved for use inside a vehicle or enclosure
and power should be removed prior to placing the light in such
circumstance
» This light may be damaged if operated in icing conditions
» This light may only be dismantled by an authorized Golight
representative
»
Any violation of the above referenced misuses will be
considered grounds for warranty refusal
IMPORTANT SAFETY INFORMATION
This symbol is to alert you to important operating or servicing
instructions that appear in your instructions. Always follow basic safety
precautions when using this product to reduce the risk of injury, fire or electric shock.
This light is for off road and utility use only. It is not d
e-signed for road use as a driving light.
The RadioRay® complies with Part. 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This light and remote may
not cause harmful interference, and (2) this light and remote must accept any interference received, including interference that may cause
undesired operation.
FCC RULE Part. 15.21 - Changes or modifications made by the user not expressly approved by Golight, Inc. for compliance could void the
user’s authority to operate the equipment.
For safe and efficient operation of your Golight RadioRay,
observe these guidelines:
Using your RadioRay in icing conditions could damage the gear
motors.
The remote must be kept clean and dry to avoid damage to the internal circuitry.
Your Golight RadioRay is a radio transmitter and receiver operating at 433MHz. Whenever the light is on, the internally
mounted antenna sends
out and receives radio frequency (RF) energy.
