![background image](http://html1.mh-extra.com/html/larson-electronics/golight-gl-3000-24-m/golight-gl-3000-24-m_instruction-manual_3767290002.webp)
5. Replace battery cover.
a. Depress the on/off button and hold it down. Red LED will light.
b. While holding the on/off button down, reinstall the power (replace fuse or connect vehicle battery).
c. Keep your finger on the on/off button for 5-6 seconds, and then release. The light should now be programmed.
OPERATION OF STRYKER
1. Using the remote control, turn on the light by depressing the
on/off button.
2. With the 4-way arrows on the remote control, rotate your light
to the desired location. Depending upon conditions, the wireless remote may be used up to 100 feet from the StrykerTM.
3. The speed of the light rotation can be controlled by depressing the fast/slow button one time and by depressing it
again to restore the original speed.
4. The spotlight should not be turned on when the snap on lens
cover (rockguard) is attached.
BULB REPLACEMENT
The Golight Stryker utilizes a Philips 9011 bulb, which may be purchased
IMPORTANT SAFETY
•
This light is for off road and utility use only. It is not designed for road use as a driving light.
•
The Stryker complies with Part. 15.105 of the FCC Rules. This equipment has been tested and found to comply
with the limits for a
Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
o
Reorient or relocate the receiving antenna.
o
Increase the separation between the equipment and receiver.
o
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
o
Consult the dealer or an experienced radio/TV technician for help.
FCC RULE Part. 15.21 - Changes or modifications made by the user not expressly approved by Golight, Inc. for
compliance could void the user’s authority to operate the equipment.
For safe and efficient operation of your Golight® StrykerTM, observe these guidelines:
Your Golight® StrykerTM is a radio transmitter and receiver operating at 433MHz. Whenever the light is on, the
internally mounted antenna sends out and receives radio frequency (RF) energy.
GL-3000-24-M
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
•
Modern electronic equipment, i.e. Personal medical devices such warranty gives you specific legal rights and you
may also have as pacemakers, hearing aids, etc., are shielded from RF energy. other rights. However, RF energy
may affect some electronic equipment.
•
Vehicle electronic systems may be affected by RF energy. Check with your vehicle manufacturer representative to
be sure that your Golight® StrykerTM will not affect the electronic system of your vehicle.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.