WHAT TO DO IF THE SMELL OF GAS IS PRESENT:
NEVER store or use gasoline or other flammable
vapors and liquids in the vicinity of this heater.
NEVER store a propane (LP) cylinder not
connected to this heater in the vicinity of this
heater.
NEVER connect heater to an unregulated gas supply.
NEVER obstruct the flow of combustion and
ventilation air.
NEVER use duct work in front or rear of heater.
NEVER modify this heater or operate a heater that
has been modified.
NEVER service, move or handle heater while still
hot or operating
Keep all combustible materials away from this heater.
Minimum Clearance From Combustibles
Front
Sides
Top
72 in.
12 in.
24 in.
Minimum and Maximum Inlet
Pressure
Sku
GAU-GFH-CH-18K
Min.
5 PSI
Max.
Bottle Pressure
RISK OF BURNS,
FIRE AND
EXPLOSION!
PROPANE IS AN
EXPLOSIVE GAS.
CAUTION!
HOT WHILE IN
OPERATION. DO
NOT TOUCH. KEEP CHILDREN, ANIMALS,
CLOTHING AND COMBUSTIBLES AWAY
FROM HEATER.
DANGER
WARNING
WARNING
For use with
propane (LP) gas
only.
The hose assembly
shall be pro tected
from traffic, building
material and contact with hot surfaces both
during use and while in storage.
WARNING
WARNING
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, CONNECTED TO A POWER
SOURCE, OR WHILE CONNECTED TO A FUEL SOURCE
Safety Information
GAU-GFH-CH-18K
– ALWAYS install the heater so that it is not directly
exposed to water spray, rain, dripping water, or
wind.
– Use heater in accordance with all local codes
and with CSA 5.90 U.S. (5th Ed.) Infrared
Patio Heater.
–
This heater is shipped from the factory
for use with propane (LP) gas only.
Do not
convert to any other gas. Installation must
conform to local codes, or in their absence,
with the standard for the Storage and
Handling of Liquefied Petroleum Gases ANSI/
NFPA 58 and the Natural Gas and Propane
Installation Code CSA B149.1.
– Gas supply connections should be checked
by using a 50/50 soap and water solution.
Never use a flame to check for gas leaks.
– Use only the regulator and hose assembly
provided with this heater. Inspect the
regulator/hose assembly prior to each use of
the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list, prior
to using the heater.
–
This heater is not for use on finished floors.
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
11
–
DO NOT attempt to light the heater.
–
�������������
–
Shut off gas to heater.
–
If odor continues, contact your local gas
��������������
–
DO NOT touch or use any electric switch or
any electric device that can cause a spark.
–
Immediately call your gas supplier from a
neighbors phone. Follow the gas suppliers
instructions.
–
If you can not reach your gas supplier, call
����������
–
�����������������
service agency.
