1
www.larsonelectronics.com
EXPCMR-ALG-1080P-
24
V
Installation
Before installation:
•
Make sure that the device is in good condition and all the assembly parts are included.
•
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
provide the rated voltage and wattage for the camera. See the
section.
During installation:
•
Camera Lens
: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
array shield becomes soiled, clean it only with approved products. See the
Cleaning
section.
•
Monitor impedance
: Set the monitor impedance switch to 75 Ω.
•
Power supply
:
Camera drop cable
: The camera drop cable includes two connectors:
—
Video BNC connector
: For transmission of the video signal across a coax (75 Ω) extension cable.
—
Power connector:
When applying Vdc power, observe the power polarity. See the drop cable
Step 1. Mounting the camera
Typical ceiling mounting
1.
Mark the location of the screws that anchor the mounting base
to the mounting surface. See the note above. If you are routing the drop cable through mounting
surface, also mark the position of the hole for the drop cable.
2.
Drill holes for the screws that anchor the base to the mounting surface. The mounting hardware
provided is appropriate for most surfaces. However, depending on the surface materials, more
appropriate fasteners may be required.
3.
Drill a 3/4” hole through the mounting surface for the drop cable, if necessary.
4.
Route the drop cable through the hole in the mounting surface, or through the cable guide in the
mounting base, then attach the camera assembly to the surface using the appropriate fasteners.
5.
Connect the camera drop cable to video and power extension cables.
6.
Connect the other end of the video extension cable to a video monitoring device, such as a HD-TVI
capable DVR.
NOTE
Drop cable connectors are not waterproof.
7.
Connect the other end of the power extension cable to a
24
Vdc power source. Observe the polarity
of the cable shown in the photo on page 1 of this guide.
Step 2. Camera adjustments
1.
Apply power to the camera.
resolution over RG59 coax or any standard ana
EXPCMR-ALG-1080P-
24
V
Explosion Proof 1080p Analog
Portable Observation Camera
The EXPCMR-ALG-1080P-
24
V
camera feature a 1/2.7”CMOS image sensor that delivers HD
video
log CCTV cabling up to 1600 ft. This camera must connect to
an HD-TVI compatible DVR, such as an HVR. This HD video camera is ideal for security applications that
require a high level of detail, such as facial recognition.
Features
•
CMOS image sensor
•
HD-TVI technology produces 1920 × 1080 (1080p)
3.6 mm wide angle (90°) lens captures images over large areas
•
HD-TVI technology transmits zero latency HD video resolution over coax cabling
•
•
Built-in IR with range up to 65 ft in the dark
•
True day/night (ICR) captures sharp, clear images in low light and at night
•
14 °F ~ 122 °F temperature operating range
•
IP66 weather-rated housing
Power
Connector
HD-TVI video
BNC connector
Camera drop cable connectors
What’s in the box
•
Camera assembly
•
This instruction guide
Tools you need
To install the camera, you will need:
for wattage requirement.
•
Tools and additional fasteners (may be required) for mounting the camera
•
24
Vdc power source. See
Specifications
•
Phillips screwdriver
•
Video and power extension cable
Lens
NPT Hub
Adjustable
mounting
bracket
