EXP-TP-RL-1XFX5R
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
VEHICLE POWER REQUIREMENTS
Maximum ampere draw from a completely discharged lantern is 2 Amps for the first 10 hours and .035 Amps from then
on. Nominal charging current is 1 Amp.
USAGE TEMPERATURE
-24°C (-11.2°F) to +44°C (+111.2°F)
USING THE TRIPOD
1.
To assemble the tripod, begin by loosening the black adjustment knob on the
tripod base. Slide the center pole through the adjustment sleeve until the legs
are fully deployed. Tighten adjustment knob so legs stay fixed in place.
2.
Connect the single Deutsch connector coil cord to light.
3.
Loosen black adjustment knob for each sleeve to extend tripod. Extend top
pole, then bottom pole when elevating.
4.
Tighten adjustment knob once desired height is achieved.
5.
Attach power cord to charge lamp. Charge requires at least 8 hours.
OPERATION
The light head features an Explosion Proof Rechargeable LED Flashlight. It is
powered by the power switch located under the handle and will illuminate up to 10
hours. Do not look directly into lens when powering.
Lamp head can be adjusted in multiple directions. Simply lift up on lamp head for
vertical tilt and rotate.
Modes:
Lamp features the following modes. To select a mode, hold down the power button
until the desired mode is achieved. A second press of the power button will turn off
the light.
Front Lamp
Mode
Rear Signal Lamp
Mode
1
X
STEADY
X
STEADY
2
X
STEADY
-
OFF
3
X
STEADY
X
STROBE
4
X
STEADY
X
ROTATING
5
X
S.O.S.
X
S.O.S.
USE AND CARE
Always check damaged or worn out parts before using the work light. When work
light is not in use, store it in a secure place out of the reach of children. Inspect for
good working condition prior to storage and before re-use.
Should further information not covered by these instructions be required, please
contact Larson Electronics at 1-800-369-6671 or
for
further assistance.
Please visit LarsonElectronics.com for
Warranty
and
Return
information.
- Light Head
Adjustment
Points
-Leg Sleeve
Base Removal &
Power Switch
