II. Battery Replacement
2
I. Replacement
1. Loosen the locking screw located on the
side of the lens cap.
NOTE: Do NOT attempt to
completely remove the locking screw. Doing so
is not necessary and may damage the threads.
The screw simply needs to be loosened enough
to allow the lens bezel to unscrew.
2. Unscrew the lens bezel from the housing in a
counter-clockwise direction.
3. Turn the light upside down and carefully
shake the light in order to remove the reflector
/ battery carrier. Allow the reflector / battery
carrier to slide into your hand.
WARNING: Do
NOT touch the reflector surface with your finger.
Doing so may damage the reflector surface.
4. Using 3 – AA batteries (make sure that all
3 batteries are of the same model), install the
batteries in the carrier paying close attention to
the markings on the battery carrier for proper
battery terminal polarity alignment.
5. Align the reflector / battery carrier so that
the switches on the carrier are aligned with the
switches on the housing. Carefully insert the
reflector / battery carrier back into the flashlight
housing until it is fully seated in the housing.
WARNING: Be careful to not touch the reflector
surface with your finger. Doing so may damage
the reflector surface.
6. Replace the lens bezel by screwing it onto
the housing in a clockwise direction.
7. Tighten locking screw.
CAUTION: Do NOT
over-tighten. Doing so may damage the threads
and impact the light’s Intrinsic Safety.
Locking Screw
