EXC-EYM-12C-1523
Explosion Proof Cord Repair Kit and Extension Cable
Explosion Proof 1523 Cord Cap - 12' 16/3 SOOW
Instruction Manual
The EXC-EYM-12C-1523 from Larson Electronics is an explosion proof cord repair kit and extension cable that allows
operators to repair or replace on their equipment. Utilizing this explosion proof cord repair kit can reduce repair costs and
increase the efficiency of already existing equipment. The EXC-EYM-12C-1523 is available in both 1/2" and 3/4" seal off
sizes to fit a variety of different equipment.
Explosion Proof
Cord Cap
Explosion Proof
Seal
Fitting
Packing
Fiber and
Cement
Compound
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
Installation
NOTE: Be sure power is off before installing!!
C
ut back damaged portion of existing cord until all damage is
removed before completing these connections.
We strongly encourage a licensed electrician install this
product
, in all locations especially in outdoor areas where
weatherproofing may be required.
Secure each pair of wires according to the diagram. Utilize a
junction box or similar device and take precautionary steps for
weatherproofing all connections if installed in a location where
water may come in contact with the unit. Take all necessary
steps to ensure explosion proof status is maintained. Ensure
the unit is properly grounded and that wiring is done according
to all local and national electrical/building codes.
Mate cord
cap with compatible receptacle outputting correct voltage once
installation is complete and all seals are set. See following
page for specifics pertaining to the explosion proof seal fitting
installation.
WARNING:
USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE. WHEN EXTENSION
CORD IS CONNECTED TO A POWER SOURCE IN HAZARDOUS AREA, PLUG AND MATCHING RECEPTACLE
MUST BE SUITABLE FOR HAZARDOUS LOCATION INVOLVED. IMPROPER USE OF THIS DEVICE, ASSOCIATED
PLUG, RECEPTACLE, AND CORD CAN LEAD TO SERIOUS INJURIES OR DEATH TO PERSONNEL.
PERIODIC INSPECTION OF THE RECEPTACLE AND CORD IS NECESSARY.
THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY
ARE FOUND, THE CORD MUST BE REPLACED BEFORE RESUMING USE OF THE UNIT.
ELECTRICAL POWER SUPPLY MUST BE “OFF” BEFORE AND DURING INSTALLATION AND MAINTENANCE.
INSTALLATION AND MAINTENANCE PROCEDURE MUST BE PERFORMED BY A TRAINED AND COMPETENT
ELECTRICIAN.
IF ANY PARTS OF THE RECEPTACLE OR PLUG APPEAR TO BE MISSING, BROKEN, OR SHOW SIGNS OR
DAMAGE, DISCONTINUE USE IMMEDIATELY. REPLACE WITH THE PROPER REPLACEMENT PART(S) BEFORE
CONTINUING SERVICE.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT
1-877-348-9680
FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of children
when not in use. Inspect for good working condition prior to storage and before re-use.
