EPL-SL-2-LED-ITG-M2
Explosion Proof LED String Lights
120-277V AC - (2) LED Lamps - 360° - Y Connector
Instruction Manual
Thank you for your purchase of the Larson Electronics EPL-SL-2-LED-ITG-M2 string light.
WARNING
TO AVOID THE RISK OF FIRE, EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,
INSPECTED AND MAINTAINED BY A QUALIFIED ELECTRICIAN ONLY, IN ACCORDANCE WITH ALL
APPLICABLE ELECTRICAL CODES.
TO AVOID ELECTRIC SHOCK:
•
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
PRODUCT MUST BE CONNECTED TO A WIRING SYSTEM WITH AN EQUIPMENT-GROUNDING
CONDUCTOR.
TO AVOID EXPLOSION:
•
MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.
•
ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUS
ATMOSPHERE.
•
DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCT
NAMEPLATE.
•
DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED OR
DAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.
•
ALL FASTENERS SHOULD BE PROPERLY SEATED.
The Larson Electronics EPL-SL-2-LED-ITG-M2 Explosion Proof LED String Light is ideal for general lighting, detailed tasks
and inspections in hazardous locations. This 60-watt unit features a total of two LED handlamps, which provides 6,000
lumens of total output during use. A unique angled board design ensures 360° of comprehensive illumination. The
explosion proof light is equipped with a Y connector, which has a single input cord with an explosion proof cord cap
branching out to the LED lights.
Operation
Position device near work area for operation. Run cable to nearby power source. Insert
and twist-lock explosion-proof plug into a compatible receptacle within the hazardous
environment. See
Plug Operation
below
for specifics on operating the explosion proof
cord cap with compatible explosion proof receptacle
within the hazardous area
.
The light
is "instant on", meaning it will illuminate as soon as it is supplied with power.
PLUG OPERATION
Electrical connection between plug and compatible receptacle is accomplished after plug
fully inserts into receptacle and rotated clockwise.
WARNING:
Check product label for correct voltage! Failure to comply could
result in damage to the fixture which may not be covered by
any
warranty.
1.
Lift receptacle door and locate polarization on mating plug pin and
receptacle face. Insert plug straight all
the way into receptacle until it
cannot go further.
2.
Rotate plug clockwise limit (37º), this closes internal contacts and
completes circuit. This also
mechanically locks plug into receptacle so it
cannot be pulled out.
3.
To remove plug, push plug inward and turn to counterclockwise, pull plug
straight out.
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
