EPL-LP-48W-LED
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
MAINTENANCE
To avoid personal injury, disconnect power to the light and allow the unit to cool down before performing maintenance.
WARNING:
Risk of electric shock. Removal of the lens will void the warranty.
Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine checks to be made on
a yearly basis. Frequency of use and environment should determine this. It is recommended to follow an Electrical
Preventive Maintenance Program as described in NFPA 70B: Recommended Practice for Electrical Equipment.
The lens should be cleaned periodically as needed to ensure continued photometric performance. Clean the lens with a
damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid cleaner.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated
This LED Luminaire should require a minimum amount of maintenance. If any unforeseen repairs are required then
always observe explosion protection regulations and requirements.
WARNING:
This LED Luminaire should not require any electrical maintenance. Never open the luminaire (other than the junction
box lid if supplied); there are no user- serviceable parts inside.
Inspection
Within the scope of a maintenance or inspection routine the following should be included: protective hoses covering the
connection cables. Cable entries must be free of corrosion. Perform visual mechanical and electrical inspections on a
regular basis. We recommend routine checks to be made on a yearly basis. Frequency of use and environment should
determine this. It is recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:
Recommended Practice for Electrical Equipment
The lens should be cleaned periodically, as needed, to ensure continued photometric performance. Clean the lens with
a damp, non-abrasive, and lint- free cloth. If not sufficient, use mild soap or a liquid cleaner. Do not use and abrasive,
strong alkaline, or acid cleaners as damage may occur.
Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or contamination (i.e. excessive
dust build-up). Clean with a non-abrasive, damp cloth, if needed.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire
shall be replaced.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR
INSTALLATION REQUIREMENTS. SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE
REQUIRED, PLEASE CONTACT LARSON ELECTRONICS AT
1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
