EPL-EMG-CM-42W
INSTALLATION, OPERATION & MAINTENACE DATA SHEET
(EPL-EMG-CM SERIES COMPACT FLUORESCENT EMERGENCY FACTORY SEALED LIGHTING FIXTURES)
IMPORTANT SAFEGUARDS
– READ AND
FOLLOW ALL SAFETY INSTRUCTIONS.
NOTE: LAMP MUST BE INSTALLED BEFORE OPERATING
Remove globe assembly, unpack bulb and insert into socket.
See installation instruction sections 4 & 5 for removal of globe assembly.
NOTE:
Read this sheet carefully before beginning installation.
• Do not use this equipment for other than the intended use as specified on equipment
nameplate.
•
WARNING:
Turn off the supplying circuit before beginning installation, or
performing any maintenance including re-lamping.
• Do not install near gas or electric heaters.
• Do not attempt to service battery. The emergency ballast contains a sealed, no-
maintenance battery. Contact manufacturer for information on replacements.
• Batteries must be recycled or disposed of properly.
• Servicing should be performed by qualified service personnel.
• The use of accessory equipment not recommended by the manufacturer can
cause an unsafe condition
• Equipment should be mounted in locations and at heights were it will not readily be
subjected to tampering by unauthorized personnel.
• The emergency ballast is for use with quad pin compact fluorescent lamps only.
INSTALLATION:
Important Note:
1. All installations must comply with the applicable local and/or National Electrical
Code.
2. Before installing, check the fixture nameplate to be sure you have the correct
fixture.
3. Verify ground continuity in the electrical system.
4. The emergency ballast must be connected to an unswitched power source.
5. Refer to nameplate for specific ambient and supply wire temperature rating.
