EPL-48-2L-LED-BLC
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
1
REPLACING POLYCARBONATE LENS
FOR EPL MODEL COVERS
The polycarbonate lens cover is intended to protect the lamps from paint overspray. Simply replace
the polycarbonate lens cover when dirty instead of the glass pyrex lens tubes. Replacement
overspray covers may be purchased from Larson Electronics, Part Number: EPL-48-2L-187-RL
Follow the basic steps below.
1. Replacing lens:
Grasp one side and pull away from lamp to remove old lens.
2. Install polycarbonate lens:
Start with one side and insert lens under the lip of lamp.
3.
Attach polycarbonate lens to the other side under the opposite lip.
A mild soap and water can be used keep the lens clean and clear. If the lens becomes dirty beyond
cleaning, the polycarbonate lens can be removed as easily as it was installed.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.