EPL-18C-150LED-RT-125C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
150W Explosion Proof LED Tank Light w/ Removable Light Head -
17,500 Lm - C1&2D1&2 - Manhole Cart
Instruction Manual
This explosion proof wheelbarrow light is designed for illumination of industrial locations. It uses the latest in
solid state lighting technology for long life, low maintenance and high efficiency.
The unique design focuses the light where it is needed, giving improved efficiency over a conventional HID
luminaire.
An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any nominal
120-277V AC 50/60 Hz power supply without any variation in light output.
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected and
maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is within the luminaires’ voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
The light fixture on this wheelbarrow cart is factory sealed.
CART OPERATION
The wheelbarrow cart assembly consists of 3 parts:
1.
Light head
2.
Extension Pole
3.
Wheelbarrow cart base
To assemble cart, place extension pole over center slot of wheelbarrow cart. Tighten hand screw to secure
pole. Place light head over extension pole and tighten hand screw. The wheelbarrow cart is now ready for
use.
Run power cord to a nearby receptacle outputting voltage listed on product label.
WARNING:
check nameplate for proper voltage. Damage from improper voltage may void warranty.
The operator can tilt the unit up and simply roll entire assembly to a new location once assembled. For
lower illumination needs, the extension pole can be removed and replaced with the light head.
WARNING:
Be sure all hand screws are tight before transporting! Use caution when maneuvering near
inclines or drop offs.
To adjust light head vertically, loosen hand screws on either side. Once desired angle is achieved, tighten
both hand screws to secure light in place. Loosen the single hand screw holding light head to rotate
horizontally.
Be sure all hand screws are tight before transporting!
