EPL-xx-150LED-RT-SP0010-200C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
Replacement Wiring Assembly for Portable Explosion Proof Lights -
200ft 16/3 SOOW - Exp Proof Plug
Instruction Manual
Replacement wiring assembly for portable explosion proof lights.
Includes:
200ft 16/3 SOOW cord, Explosion proof plug (exp cord cap options), Junction box, Nipple, CGB, Terminal
strip.
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected and
maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is within the luminaires’ voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
INSTALLATION
1.
Disconnect power prior to performing maintenance!
2.
Open junction box cover of existing fixture. There are nubs on top cover for opening with a screwdriver,
wrench, or similar tool. Turn cover counter-clockwise to remove.
3.
Once the top cover has been removed, pull out the wiring and make note of how they are connected.
4.
Disconnect wiring.
5.
Unscrew the CGB cord grip from the base of the junction box to remove old cord.
6.
Loosen set screw on back of light holding junction box and twist junction box counter-clockwise to
remove from the light fixture.
7.
Open top cover of new junction box.
8.
Run cord from back of light fixture through new junction box and nipple.
9.
Attach junction box to back of light while making sure no wires get twisted.
10.
Tighten set screw on back of fixture for the NPT port holding nipple and junction box in place.
11.
Make sure CGB cord grip and cord is connected to junction box and tight.
12.
Once junction box is installed and cord with cord grip is attached, make all wire connections.
13.
Tuck wires into junction box and close top cover by turning clockwise. Make sure there are no wires
protruding or getting pinched when closing top cover.
Ensure all wire connections have been made properly and that all points are closed off and tight before
operating.
WIRING
This unit comes preconfigured with the selected explosion proof cord cap. Run cord from light and plug into
matching receptacle. Follow all applicable local, state, and National Electrical Code for the hazardous area!
