EHL-LED-240X12V-50
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3 of 3
OPERATION
1.
Position light head in desired location using swivel hook.
2.
Run cable, transformer, and plug
OUTSIDE HAZARDOUS AREA
.
3.
Attach power cord from transformer to
Voltage: 240V AC
compatible
receptacle. The transformer takes 220-240V AC down to 24 VAC or VDC.
WARNING:
Check product label for correct voltage! Failure to comply could
result in damage to the fixture which may not be covered by warranty. The bulb itself
runs on low voltage specified upon purchase.
The LED lamp in this hand lamp is “instant-on” and will illuminate once power is
supplied.
LAMP REPLACEMENT
1.
Loosen set screw.
⑧
2.
Unscrew Guard/Globe assembly
⑨
from handle assembly.
3.
Replace with matching lamp.
4.
Inspect o-ring seal
⑪
. If worn or damaged, it must be replaced to
insure watertight seal.
5.
Screw globe assembly completely onto lamp base.
6.
Tighten set screw securely to 6 in-lbs.
Note:
Over tightening can deform threads.
USE AND CARE
Unauthorized modification may impair the function and/or safety of the work light
and could affect the life of the equipment. Always check damaged or worn out
parts before using the work light. When work light is not in use, store it in a
secure place out of the reach of children. Inspect for good working condition
prior to storage and before re-use.
REPLACEMENT PARTS
The
EHL-LED-240X12V-50
is designed to provide years of reliable lighting
performance. Should the need for replacement parts arise, please contact
Larson Electronics at the contact information below.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
