DCP-24x16-10A-WP
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
INSTALLATION
This transformer includes
6” wires for both the input and output connections. All leads are stripped and tinned for
equipment installation. This converter operates at 24V DC and converts it to 12V DC @
1
0 Amps. This allows users to
use 12V DC equipment on a 24V DC power supply.
Make sure power is turned off prior to wiring! Take all appropriate steps for waterproofing connections as necessary.
Connect input lead to power source. Connect equipment to output side. The connected device(s) will power once the
converter is energized. If not, check power source and connections.
NOTE:
In order to obtain the best performance and the longest operational life from these units, it is recommended that
you do not exceed 75% of the unit’s output amperage. To determine if this converter suits your desired application, add
together the total wattage of the equipment you intend to use with this unit and divide this total by 12 volts to find the total
amperage draw that will be placed upon the converter. For example, if you are using two of our LEDP10W -120E 120 watt
LED lights, 120 watts divided by 12 volts is 10 amps. This would mean the DCP is well suited as it would run at under
75% capacity to produce the necessary 10 amps. Running these units at 100% of their capacity can create excess heat
and lead to shortened converter life.
*See product nameplate for exact voltage requirements.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE
AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.