![background image](http://html1.mh-extra.com/html/larson-electronics/9200-rl-led-s-scm-wr/9200-rl-led-s-scm-wr_instruction-manual_3731494003.webp)
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
1
of
1
Wireless Remote Programming Guide
For Remote Control Lights
PROGRAMMING
Please follow the steps below in order to program, operate, and maintain the wireless remote control.
PROGRAMMING
Access the receiver board attached to the device being controlled. There is a small button
that needs to be pressed in order to program a new remote. On some models, locate the
rubber grommet with a small hole on the base of the unit. This allows pressing the button
on the receiver board without having to open the unit.
The receiver board will need power for programming. Be sure power is ran to the unit or
that the batteries are fully charged
(if applicable)
.
REMOTE
ACCESS POINT
TO PAIR NEW REMOTES
With the device in its off state (no lights on), press the program button for at least 1 second until the red LED indicator is
solid. In this instance, grab the new wireless remote control and press the
ON
button. If successful, the red indicator light
on the receiver board will flash and the device will work with the remote control.
TO FORGET ALL REMOTES
With the device in its off state (no lights on), press and hold the program button down for 8-10 seconds. The red LED on
the receiver board will begin to flash. At this point, all remotes are forgotten and will no longer control the light. Follow
steps to pair new remote for adding new remotes.
Note:
If no LED indicator is visible on the control board, check to ensure power is enabled for the unit.
OPERATION
The wireless remote has two functions. A red LED indicator light illuminates as buttons are pressed on the remote control.
If there is no indicator light, replace the batteries.
•
Press the
ON
button to turn the controlled device
ON
•
Press the
OFF
button to turn the controlled device
OFF
INDICATOR LIGHT
Note:
If the controlled device contains an on board power switch, this will act as a 3-way power switch. In this case, the
ON/OFF buttons on the remote control will be reversed and vice versa as the onboard switch is used.
BATTERY REPLACEMENT
In order to replace the batteries in the wireless remote control;
1.
Open the cover by inserting a flat head into the groove on top.
2.
Lift the board to reveal two batteries attached.
3.
Slide the batteries out of the battery holder of the remote.
4.
Stack 2 new
CR2016 batteries
with (+) facing up inside the battery holder.
5.
Replace the stack in the remote control board and snap the cover back together.
TROUBLESHOOTING
Refer to the guide below or contact the manufacturer if the device does not function properly.
Is power being supplied to the unit?
Are the batteries good in the remote control?
Is the controlled device fully charged (if applicable)?
Should further information not covered by these instructions be required, please contact Larson Electronics at 1-800-369-
6671 or
for further assistance.
Please visit LarsonElectronics.com for
Warranty
and
Return
information.