LT-4100 User & Installation Manual Rev 1.00
Web server
Lars Thrane A/S
www.thrane.eu
Page 100 of 129
GNSS and BAM
The LT-4100 system has a built-in GNSS receiver located in the LT-4130 Antenna Unit. The GNSS receiver is
used for time, date and position of the LT-4100 system, for example by the tracking application. The GNSS
receiver can be configured to operate on different satellite systems (e.g. GPS only) - this can be managed
under the GNSS module, as illustrated in Figure 124.
It is possible to configure the following functionality: GNSS and BAM on the LT-4110 Control Unit (CU - AUX)
interface.
This section describes the following configuration options:
•
GNSS module
•
GNSS (output of NMEA 0183 sentences)
•
Bridge Alert Management (BAM)
NOTE
:
The Port configuration illustrated above in Figure 124 for GNSS and BAM supports the
following baud rates: 4800, 9600, and 38400. The port is bi-directional RS-422. Only BAM
can receive data.
Figure 124: Web server
–
GNSS and NMEA output
Summary of Contents for LT-4100
Page 2: ......
Page 141: ...Lars Thrane A S Skovlytoften 33 2840 Holte Denmark www thrane eu...
