Lars Thrane Iridium Certus 200, User & Installation Manual

Page: 30 / 141

LT-4200 User & Installation Manual Rev. 1.00 Installation and Mounting
Lars Thrane A/S www.thrane.eu Page 19 of 128
Pole Mount (2.0 ” pipe, Ø 53.0mm, A4 Stainless), Antenna Unit
The Pole Mount (2.0 ” pipe, Ø 53.0mm), Antenna Unit is illustrated in Figure 19 to Figure 20.
Pole mount installation procedure:
1. Screw the pole mount onto the LT-4230 Antenna Unit using the Head screws (max torque = 12 Nm)
as illustrated on Figure 20
2. The LT-4230 Antenna Unit and pole mount can now be m ounted on the 2.0” pipe. Fasten the three
pole lock pinot screws, as illustrated in Figure 21 (max torque = 88 Nm)
3. Feed the coaxial cable through the supplied cable hose
4. Fasten the coaxial cable to the LT-4230 Antenna Unit (N connector)
5. Apply self-volcanic tape on the N connector and cable to protect against saltwater and corrosion
NOTE : The Pole Mount (2.0 ” pipe), A ntenna Unit interfaces to a pipe of maximum 2.0 ” ( 53.0 mm),
measured outer diameter.
Figure 19: Pole Mount (2.0 ” pipe), Antenna Unit.