14
®
2
31
31
SFX600/SFX1000
2
Rotor Assembly Parts
Shaft End Cap
Washer
Impeller
Magnet Axle
Rotor Shaft
(This shaft should go through
all the parts and into both
Shaft End Caps)
Washer
Shaft End Cap
SFX1500
2
3
4
You may need to reach inside the
Canister to free the Pump Motor.
STEP 2: Rotor Inspection/Replacement
The Pump
3
is consisted of a Rotor Assembly
k
and its related parts. If the Rotor and/or its parts is/are broken, or the Rotor, even in perfect condition, is not
seated in place between the Volute Cover
l
and Pump Body
x
, the Pump will not function properly.
1. Loosen the Volute Cover Lock Nut
;
or Bolts
z
(depends on the pump model), and remove the Volute Cover
l
.
2. Pull the Rotor Assembly
k
out from the Pump Body
x
.
Inspect the Rotor (see image below) to make sure that the Rotor Shaft, Magnet Axle, Impeller and other parts are intact. If either of them is broken, you can
purchase a new Rotor Assembly at
polygroupstore.com
without having to replace the whole Pump.
For more details, please see
Pool Support – Filtration System Troubleshooting
at
support.polygroupstore.com
3. Once the inspection or replacement is done, carefully insert the Rotor Assembly
k
back into the Pump Body
x
. The force of the magnet will pull the Rotor
down in place.
4. Align the Volute Cover
l
with the top Shaft End Cap, then tighten with the Volute Cover Lock Nut
;
or Bolts
z
(depends on the pump model).
5. Attach the Rubber Nozzle
2
to the outlet of the Pump Body
x
.
5. Slowly take out the Motor Assembly
3
. Be careful not to lose the Rubber
Nozzle
2
or Canister Gasket
4
.
